Landscape Addiction ~ How to fix a broken pvc pipe

How to fix a broken pvc pipe

	How to fix a broken pvc pipe
	TOOLS THAT YOU WILL NEED TO COMPLETE THIS JOB:
	--Round Point Shovel --Pipe Saw or Hack Saw --Rag --PVC Glue --Primer --Slip Fix --Coupling
1.	First, identify where the break is. Usually you can find it by looking for the soggy area or sometimes you can see it.
2.	Make sure that the sprinklers are off.
3.	Take a tarp (not necessary but will help keep the area clean) and lay it down so you can place the dirt that you dig out on it.
4.	Go to the center of the soggy area and carefully cut out the grass so you can reuse it once you finish. Dig until you can see the pipe. Make sure you dig all around the pipe so you have a nice hole to work in.
5.	Once you are done exposing the pipe, turn on the sprinklers. (If you have someone to turn them on for you while you stay and look for the break it will be easier because you will get less water in the hole). Once you have identified where the break is, mark it. (You might have to dig a bit more).
6.	Take the saw and cut out the section with the break (try to get a straight cut).
7.	Now you will need to go and get the parts to complete this job. If you are not able to identify the size of the pipe, take it with you. BUY THE FOLLOWING: A slip-fix (also known as a quick-fix) A few coupling (or the exact same fitting that you cut out if not in a straight line) A small bottle of glue and primer (don’t buy the large bottles—these items will go bad) *Don’t forget--you might need to buy a small section of pipe. Make sure that all of the items that you are buying are the same size as the section of broken pipe that you took with you*
8.	Take the slip fix and extend it out all of the way.
9.	Glue the PVC fitting that you need (example: coupler if in a straight line, elbow, tee, or 45 º).
10.	With the slip-fix fully extended, place it next to the broken pipe. Mark the broken pipe. Mark it about ½” in from the edge on both sides.
11.	Using the saw or pipe cutter, cut the pipe on the marks.
12.	Glue the fitting side first; then glue the side of the slip fix. If the pipe is dirty use primer to clean it up before the glue. If the pipe is a main line be sure to use primer as well.
13.	Wait for about ten minutes.
14.	Turn the water on and check for leaks-- If you don’t see any, bury the pipe. YOU ARE FINISHED!